Replacing The Toner Cartridge; Upgrading A Memory Module - Samsung SCX-5935 Series User Manual

PARTS
AVERAGE YIELD
Tray rubber pad Approx. 100,000 pages
Pickup roller Approx. 150,000 pages
a. It will be affected by operating system used, computing performance,
application software, connecting method, media type, media size and
job complexity.
To purchase maintenance parts, contact the source where you bought the
machine.
Replacing maintenance parts can be performed only by an authorized
service provider, dealer, or the retailer where you bought the machine. The
warranty does not cover the replacement of any maintenance parts after
their lifespan.

REPLACING THE TONER CARTRIDGE

Click this link to open an animation about replacing a toner cartridge.
When the toner cartridge is completely empty:
• Toner cartridge is worn. Replace with new one appears on the
display.
• The machine stops printing. Incoming faxes are saved in memory.
At this stage, the toner cartridge needs to be replaced. Check the type of the
toner cartridge for your machine. (See "Available supplies" on page 124.)
1. Open the front cover.
2. Pull the toner cartridge out.
3. Remove the new toner cartridge from its bag.
4. Slowly shake the cartridge five or six times to distribute the toner evenly
inside the cartridge. It will assure maximum copies per cartridge.
If toner gets on your clothing, wipe it off with a dry cloth and wash
clothing in cold water. Hot water sets toner into fabric.
a PART NAME
RPR-PAD
CASSETTE
ROLLER-PICK UP
Supplies and accessories_ 125
Do not touch the green underside of the toner cartridge. Use the
handle on the cartridge to avoid touching this area.
5. Hold the toner cartridge by the handle and slowly insert the cartridge into
the opening in the machine.
Tabs on the sides of the cartridge and corresponding grooves within the
machine will guide the cartridge into the correct position until it locks into
place completely.
6. Close the front cover. Make sure that the cover is securely closed.
NECESSARY PRECAUTIONS TO TAKE WHEN
INSTALLING ACCESSORIES
• Disconnect the power cord.
Never remove the control board cover while the power is turned on.
To avoid the possibility of an electrical shock, always disconnect the
power cord when installing or removing ANY internal or external
accessories.
• Discharge static electricity.
The control board and internal accessories (network interface card or
memory module) are sensitive to static electricity. Before installing or
removing any internal accessories, discharge static electricity from your
body by touching something metal, such as the metal back plate on any
device plugged into a grounded power source. If you walk around before
finishing the installation, repeat this procedure to discharge any static
electricity again.
• Activating the added accessories in the PS driver properties.
After installing an accessory such as an optional tray, PS driver users
must do the additional setting. Go to the PS printer properties and set
the added accesorry activated.
When installing accessories, the battery inside the machine is a
service component. Do not change it by yourself.
There is a risk of an explosion if battery is replaced by an incorrect
type. Dispose used batteries according to the instructions.

UPGRADING A MEMORY MODULE

Your machine has a dual in-line memory module (DIMM). Use this memory
module slot to install additional memory.
The machine has two memory slots with a factory pre-installed memory
module in one slot. When you are expanding the memory capacity, you can
add a memory module to the vacant memory slot. It is strongly
recommended that you expand a memory module in the vacant memory
slot, and not by removing a pre-installed memory module. If your machine