Appendix; Automatic Degaussing To Remove Colour Patches - Samsung WS-32Z308T Owner's Instructions Manual

Appendix

Automatic Degaussing to Remove Colour Patches

A degaussing coil is mounted around the picture tube, so you do not normally need to degauss the television manually.
If you move the television to a different position and colour patches appear on the screen, you must:
Switch the television off by pressing the " " button (On/Off) on the television
◆
Unplug the television from the wall socket
◆
Leave the television power-off for about 30 minutes so that the automatic degauss function can be activated,
◆
and then press the "POWER " button on the remote control.
☛
If your television will be left unattended, press the " " button (On/Off) to turn your television off.
Troubleshooting:
Before contacting Samsung after-sales service, perform the following simple checks.
If you cannot solve the problem using the instructions below, note the model and serial number of the television and contact your
local dealer.
No sound or picture
Normal picture but no sound
No picture or black and white picture
Sound and picture interference
Blurred or snowy picture, distorted sound
Remote control malfunctions
Before Contacting Service Personnel
◆ Check that the mains lead has been connected to a wall socket.
◆ Check that you have pressed the " " button (On/Off) and the POWER button.
◆ Check the picture contrast and brightness settings.
◆ Check the volume.
◆ Check the volume.
◆ Check whether the volume MUTE (
pressed.
◆ Adjust the colour settings.
◆ Check that the broadcast system selected is correct.
◆ Try to identify the electrical appliance that is affecting the television, then
move it further away.
◆ Plug your television into a different mains socket.
◆ Check the direction, location and connections of your aerial.
This interference often occurs due to the use of an indoor aerial.
◆ Replace the remote control batteries.
◆ Clean the upper edge of the remote control (transmission window).
◆ Check the battery terminals.
English - 29
) button on the remote control has been