Control Panel - Farberware FCM12SS Millenium Use And Care Instructions Manual

CONTROL PANEL

FIGURE 2
Power Select ON/OFF Button. Press this Button to turn the unit
ON to start the brewing process. You can also turn the unit OFF
by pressing this Button when the brewing cycle is complete. The
Red ON Light, above the ON/OFF Button, will illuminate when
the Coffeemaker is ON. The Green AUTO Light, above the DRIP
Button, will illuminate when the Coffeemaker has been
programmed.
HR Button. Use this Button to display the correct hour when
setting the time.
MIN Button. Use this Button to display the correct minute when
setting the time.
PROGRAM Button. Use this Button to program your Coffeemaker
to start brewing at a specified time.
BREW STRENGTH BUTTON. Use this Button to select a stronger
strength of brew. To ensure optimum flavor, the Brewing Strength
Selector regulates the brewing process based upon the amount of
coffee being prepared. When preparing 4 cups or less, press this
Button. A cup will appear in the Display. This will slow down the
flow of water into the Filter Basket to provide a rich coffee flavor
by promoting a better saturation of grounds for smaller quantities.
When preparing 5 or more cups, reset the selector. The cup will
disappear from the window. This will prepare a full pot of coffee
at the normal rate, allowing ample time for the grounds to be
saturated, without imparting a bitter taste.
DRIP Button. This Button is used to initiate the programmed pre-
set brew time. You may also cancel the pre-set brew time by
pressing this Button.
5 5