Zone Setup; Controller Setup - Russound SIX-SOURCE CONTROLLER CAM6.6 Instruction Manual

Six-zone, six-source controller; six-zone, six-source am/fm receiver
Hide thumbs Also See for SIX-SOURCE CONTROLLER CAM6.6:
Table of Contents

Advertisement

INSTALLER
INSTALLATION MENU
ZONE SETUP (ZonSu)
NOTE: This procedure should be performed using the keypad installed in the zone to be configured.
See Zone Setup - Flow Chart on page 71
Zone Setup allows the installer to adjust properties of the UNO Keypad controlled CAM6.6 zone. This
series of menus allows the system's zones to be configured for these properties:
ZON VOL TRIM (ZonVT)
MASTER ENABL (MstEn)
1. ZON VOL TRIM
(ZonVT)
2. SYSON ENABLE
(SysOn)
3. PARTY ENABLE
(PtyEn)
4. MASTER ENABLE
(MstEn)
5. MUTE ENABLE
(MutEn)
CTRLR SETUP (CtlId)
Controller Setup is the basic configuration of the controller. This setup menu selects the options for
Controller ID and Factory Initialization. See Controller Setup - Flow Chart on page 72
1. CONTROLLER ID
(CtlId)
58
SYSON ENABLE (SysOn)
MUTE ENABLE (MutEn)
This feature allows the installer to adjust the output volume to
each zone. -16dB (lowest) to 0dB (max)(-3DB default).
This feature is either disabled or enabled. If disabled (default), an
All On command activated from another zone will not turn on the
disabled zone. If enabled, an All On command activated from
another zone will turn on the enabled zone.
This feature is either disabled or enabled. If disabled, Party Mode
activation from another zone will not affect the disabled zone. If
enabled (default), the zone will participate with Party Mode.
This feature is either disabled or enabled. If disabled, the zone
cannot host a master keypad during Party Mode. If enabled
(default), the zone has the option of hosting the Master keypad.
This feature is either disabled or enabled. It allows the option of
enabling or disabling muting in a zone. If disabled, the zone will
not mute. If enabled (default), the zone will be muted when a
mute signal is received.
This defines the Controller ID for this system. The default is 1 but
when multiple controllers are used, each additional controller ID
must be sequential and unique and be set before being connect-
ed to the system. Note that the system must be restarted before
the controller will assume the new ID.
PARTY ENABLE (PtyEn)
(continued next page)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cam6.6t

Table of Contents