Installation Menu Overview - Russound SIX-SOURCE CONTROLLER CAM6.6 Instruction Manual

INSTALLER

INSTALLATION MENU OVERVIEW

There are three item types in the installation menu:
Menu –
Procedure –
Feature –
The following UNO-S1 and UNO-S2 buttons are used to navigate and make selections while using
the installation menus. The UNO-TS2 does not support access to the Installation Menu.
UNO-S1 UNO-S2
UNO-S1 Keypad Five-character Display
The UNO-S1 keypad abbreviates information as necessary to appear in its five-character display.
In the following menu procedures, the UNO-S1 five-character abbreviation is shown in parentheses
underneath the 12-character version.
48
"
Folder" that holds procedures and/or feature options.
A series of steps to perform a guided operation, such as configuring a button.
The actual settings that will change the system configuration.
Setup button (located under cover plate on the keypad's right side) - Press
and release while in normal operating mode to enter the Installation Menu.
Press to back out of any procedure and return to beginning of Installation
Menu, then to normal operating mode.
Adjust feature setting (increment)
Adjust feature setting (decrement)
Go to next menu / procedure / feature. Not available while performing a pro-
cedure
Go to previous menu / procedure / feature. Not available while performing a
procedure
Enter menu / begin procedure / show current feature setting. While perform-
ing a procedure, it is also used to advance to the next sequential feature
setting once the current feature has been viewed or adjusted.
Button Function