Operation - Royal Sovereign RBC-1003BK Owner's Manual

oPeRAtIon

1. Plug in power cable and turn power switch on.
2. Select counterfeit detection mode.
To use ultraviolet (UV), magnetic (MG), and/or dimension (DD) counterfeit detection while counting, press the corresponding buttons
on the control panel.
The dimension (DD) counterfeit detection sensitivity level is preset on level 1 (highest level). To adjust the sensitivity level, press SET.
Preset display window will display "SE". Use the keypad to select a level from 1-5, 1-highest, 5-lowest. Press SET to store the setting.
3. Select bill counting settings.
Bill Counting Mode
The bill counting mode is preset on type 2. To adjust the counting mode, press SET twice. Preset display window will display "F". Use
the keypad to select a type 1-3. Type 1 will not count counterfeit or irregular bills and stop counting to allow removal of bill(s) in
question, and allow re-insertion of all bills into hopper to restart counting from zero. Type 2 will stop counting when a counterfeit or
irregular bill is detected and include these bills in the master count (shown on the count display). Type 3 will count counterfeit or
irregular bills and continue counting, unless there is a jam error (either EA2, two or more bills counted as one, or EA3, part of one bill
overlapping another bill), in which case the count may be inaccurate. In this case, bill(s) in question are counted, and the machine will
stop to allow re-insertion of all bills into hopper to restart counting from zero.
Add Mode
To continuously add totals for a cumulative total when counting several batches of bills, press ADD. The ADD indicator light will turn on.
Batching Mode
The machine is preset to common counting mode, which automatically counts all bills placed into the hopper. To count bills in batches,
press BATCH. Batching is preset to 100 bills. To change batch amount, press C to clear, and use the keypad to enter a batch number
between 1 and 999. Press set to save the setting.
Auto/Manual Start Modes
The machine is preset to automatically start counting bills once placed into the hopper. To change to the manual start mode, press
MNL, insert the bills into the hopper, and press RESTART.
9
RBC-1003BK