Vivotek AP-FXC-0150 Quick Installation Manual

AP-FXC-0150 and AP-FXC-0250 PoE Extender
Quick Installation Guide
AP-FXC-0250
INTRODUCTION
The AP-FXC-0250 is a PoE extender capable of feeding 15.4/30W power to powered devices for a distance of up to 300
meters. Multiple extenders can be cascaded to increase the cabling distance and the number of powered devices.
PACKAGE CONTENTS
• 1x PoE extender
IMPORTANT:
1. Install the device in a ventilated and dry place, that is free of electromagnetic source, vibration, moisture, and dust.
2. Make sure the ventilation openings on the extender are not blocked.
3. Use CAT5 or 6 UTP/STP cables. Avoid using low-quality cables, which will seriously limit the cabling distance.
CONNECTION
Following are the conditions for making the cabling:
1. Use 18~19Ω, 24AWG CAT5 cables.
2. Typical VIVOTEK cameras stream size feature = 1080p@30fps - 6Mbps; 720p@30fps - 3Mbps.
Make sure the combined bandwidth consumption does not exceed the uplink bandwidth from the PoE switch.
3. The transaction on the PoE extender consumes 2W of power. Therefore, on Line2, the total power requirement is:
C1*+C2+C3+R1**+R2+(5W***x5).
If every camera consumes 5W, the total consumption is 44W.
* Cn = camera consumption,
** Rn = extender consumption, 2W.
*** A typical 100 meters connection induces a 5W power loss due to resistance.
AW-FED-0500
PoE switch
Uplink
Line2
LED DEFINITIONS
POWER Green ON
Green OFF
PoE IN Green ON
Fast blinking
OFF
OUT# Green ON
OFF
• 1x Quick Installation Guide
100m
AP-FXC-0250
R1
100m
Power link is connected from the PoE source.
Power is off.
PoE IN port is connected.
Data is being transmitted or received.
No connection.
Port is linked to a powered device.
No device is connected.
Part no.: 625029100G
AP-FXC-0250
R2
100m
100m
100m 100m
C1
C2
C3