RIDGID MS1290LZA Operator's Manual page 27

OPERATION
TO MAKE NON-SLIDING CUTS
WARNING:
Securely tighten the slide lock knob when making
any non-sliding cuts. Failure to tighten the knob
could result in the saw head moving during the
cutting operation.
TO MITER CUT / CROSS CUT
See Figures 33 - 34.
A cross cut is made by cutting across the grain of the
workpiece. A straight cross cut is made with the miter table
set at the 0 position. Miter cross cuts are made with the
°
miter table set at some angle other than 0
 Make sure the slide lock knob is tightened securely.
 Raise saw arm to its full height.
 Lift the miter lock lever to unlock. Rotate the miter table
until the pointer aligns with the desired angle on the miter
scale.
NOTE: You can quickly locate 0°, 15°, 22.5°, 31.6°, 45°,
and 60° left or right by spinning the miter thumbwheel up.
The lock plate will seat itself in one of the positive stop
notches, located in the miter table base.
 Push the miter lock lever down to lock the miter table.
 Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
the convex side against the fence. If the concave edge
of a board is placed against the
collapse on the blade at the end of the cut, jamming the
blade. See Figures 47 - 48.
 When cutting long pieces of lumber or molding, support
the opposite end of the stock with a roller stand or with
a work surface level with the saw table. See Figure 40.
 Align cutting line on the workpiece with the edge of saw
blade.
 Grasp the stock firmly with one hand and secure it against
the fence. Use the work clamp or a C-clamp to secure
the workpiece when possible.
 Before turning on the saw, perform a dry run of the cut-
ting operation to make sure that no problems will occur
when the cut is made.
 Grasp the saw handle firmly. Depress the switch lock
with thumb then squeeze the switch trigger. Allow several
seconds for the blade to reach maximum speed.
 Slowly lower the blade into and through the workpiece.
 Release the switch trigger and allow the saw blade to
stop rotating before raising the blade out of workpiece
and removing the workpiece from the miter table.
.
°
fence, the board could
27
WORK
CLAMP
CROSS CUT
WORK
CLAMP
MITER CUT
Fig. 33
Fig. 34