Spraying Precautions; Breathable Air Warning - RIDGID GP90150A Operator's Manual

15. Tanks rust from moisture build-up,
which weakens the tank. Make sure to
drain tank daily and inspect periodical-
ly for unsafe conditions such as rust
formation and corrosion.
16. Fast moving air will stir up dust and
debris which may be harmful.
Release air slowly when draining
moisture or depressurizing the com-
pressor system.

Spraying Precautions

Do not spray flammable
materials in vicinity of open
flame or near ignition sources
including the compressor unit.
19. Do not smoke when spraying paint,
insecticides, or other flammable sub-
stances.
20. Use a face mask/respirator when
spraying and spray in a well ventilat-
ed area to prevent health and fire
hazards.

Breathable Air Warning

This compressor/pump is not equipped and should not be used "as
is" to supply breathing quality air. For any application of air for
human consumption, the air compressor/pump will need to be fitted
with suitable in-line safety and alarm equipment. This additional
equipment is necessary to properly filter and purify the air to meet
minimal specifications for Grade D breathing as described in
Compressed Gas Association Commodity Specification G 7.1 - 1966,
OSHA 29 CFR 1910. 134, and/or Canadian Standards Associations
(CSA).
DISCLAIMER OF WARRANTIES
In the event the compressor is used for the purpose of breathing air
application and proper in-line safety and alarm equipment is not
simultaneously used, existing warranties shall be voided, and
Campbell Hausfeld disclaims any liability whatsoever for any loss,
personal injury or damage.
17. STOP the engine whenever leaving the
work area, before cleaning, making
repairs or inspections. When cleaning,
repairing or inspecting, make certain all
moving parts have stopped. Disconnect
the spark plug wire and keep the wire
away from the plug to prevent acciden-
tal starting.
18. Allow engine to cool before storing.
21. Do not direct paint or other sprayed
material at the compressor. Locate
compressor as far away from the
spraying area as possible to mini-
mize overspray accumulation on the
compressor.
22. When spraying or cleaning with sol-
vents or toxic chemicals, follow the
instructions provided by the chemi-
cal manufacturer.
5