Table of Contents
Advertisement
A
SSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two
included hex keys, assembly requires a phillips screwdriver
wrenches
Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each
drawing is the key number of the part, from the PART LIST on pages 24 and 25. The number following the key
number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part
is not in the parts bag, check to see if it has been pre-assembled.
M4 x 16mm
M4 x 16mm Round
Screw (89)–30
Head Screw (91)–6
M8 x 13mm Button
Screw (90)–8
M8 x 47mm Button Screw (110)–2
1. Orient the Front Stabilizer (3) as shown. Attach the
Front Stabilizer to the Frame (1) with four M8 x 65mm
Button Screws (95) and four M8 Split Washers (85).
Next, attach the Front Shield (38) to the Front
Stabilizer (3) with two M4 x 16mm Round Head
Screws (91).
Then, tighten the two Frame Cushions (106) into the
underside of the Frame (1).
, a rubber mallet
M8 Split
Washer
(85)–11
M8 x 16mm Button
M8 x 20mm Button
Screw (94)–4
Union Set (86)–2
, and pliers
M8 x 18mm
Washer (93)–4
Washer (103)–2
M8 x 25mm Patch
Screw (118)–2
Screw (123)–2
M8 x 65mm Button Screw (95)–8
1
91
38
4
, two adjustable
.
M8 x 23mm
M8 x 25mm
Washer (119)–2
M8 x 25mm Button
Screw (100)–1
1
3
85
85
95
95
106
Hide quick links:
Advertisement
Table of Contents
