Connecting A Tv And Vcr - RCA RV3693 User Manual

Appendix A: Connecting the Receiver
TV and VCR
This connection provides
• stereo or surround sound from TV programs
broadcast in stereo
• stereo, surround sound or mono sound from a VCR
• viewing one channel on TV while recording another
channel
To use this connection, you
Should have
• (3) paired (red/white) stereo cables
• (3) single (yellow) video cables
• (2) coaxial cables
To Connect
1. Connect the cables as shown in the
diagram below.
Using This Connection
To watch TV programs
1. Turn off the VCR.
2. Press TV and tune to a channel.
To watch or play a tape on the VCR
1. Press VCR1.
2. Press PLAY.
To record one program and watch another
1. Press VCR1 and tune to a channel.
2. Begin recording.
3. Make sure TV/VCR switch on the
VCR is set to TV.
4. Press TV and tune to a channel.
If your TV has more than one video
input, make sure the VCR1, VCR2 and
DSS buttons tune the TV to the same
channel that the receiver monitor
out is plugged into.
Refer to the TV's user's guide for
more information.
CABLE
IN
BOX
OUT
VCR
IN
OUT
VIDEO R L
TV
L/MONO RIGHT
INPUT 1
L/MONO RIGHT
INPUT 2
L/MONO RIGHT
INPUT 3
AUDIO
RECEIVER
IN
VCR 1
VCR 1
IN
L
R
L
R
TV
OR ANTENNA
IN FROM ANT
CH3
CH4
OUT TO TV
VIDEO S-VIDEO OUTPUT VIDEO
BRIDGED
FROM
INPUT 1
VIDEO VIDEO
FIXED
OUTPUT
VIDEO
VIDEO S-VIDEO
TV TUNER
OUTPUT
ANT B
ANT A
SIGNAL
SOURCE
VIDEO
OUT VCR 2/ MONITOR
LD DSS OUT
VCR 2/ DSS
OUT LD
AUDIO
1
AUDIO
2
AUDIO SUB WOOFER
IN OUT
CD SOURCE TAPE/MD OUT (MONO)
L/MONO RIGHT
L/MONO RIGHT
L/MONO
RIGHT
39