Complete The Initial Setup; Choose The Menu Language; Tuning To A Channel - RCA 27F524T User Manual

SETUP
Go Back
Auto Ch. Search tu
List & Labels
Closed Caption
Favorite CH
Language
Auto. format
AUTO CHANNEL SEARCH
Go Back
Signal Type tu
Start
Search Percent
Analog Channels
Digital Channels
SETUP
Go Back
Auto Ch. Search
List & Labels
Closed Caption
Favorite CH
Language tu
Auto. format
_12
analog channel
example entry
012-1_ _
Digital channel
example entry
Chapter 1

Complete the Initial Setup

AUTO CHANNEL SEARCH is the first menu you should see when you turn on
...
the TV. (It is located from this path Main Menu/Setup/Auto Channel Search).
...
... It allows the TV to search for all channels viewable through your digital and
...
analog connections. This is sometimes called auto programming.
English...
4:3
1. From the Auto Channel Search menu press the right arrow button to choose
the Signal Type (Antenna or Cable). The default is Cable.
2. With the Signal Type chosen, press the down arrow button to select Start
and press OK. AUTO CHANNEL SEARCH runs as it finds all the available
channels. (This step can take some time, depending on your content
Cable...
provider).
...
0
3. Once the search is complete, you can begin watching TV. For information
0
on customizing your channels or menu options, go to Chapter 3.
0
Note: After you complete the Auto Channel Search you may see an
additional screen."Time stored in the TV may be incorrect after a
loss of power. Please check the time in the Time menu" may appear,
reminding you that the time setting is incorrect. Go to page 33 for more
information.
...
...
...

Choose the Menu Language

...
English...
4:3 To set the language, use the arrow buttons to highlight Language. The default
language is English. To choose another language, press the right arrow button
on the remote, choose the language and press OK.

Tuning to a Channel

Analog station numbers display on your TV in a rectangle as you enter the numbers. You can
enter digits to access a channel. In the example below, you can enter 12 or 012 to get the
same channel. To enter a one-digit channel, such as channel 8, just press 8. After entering the
channel, press OK. The CLEAR button on the remote clears all entries.
Digital channels can have both primary channels (like the analog channel number) and
subchannels. Digital station numbers display in a larger rectangle that can contain up to eight
numbers. Numbers to the left of the - (dash) are the main channel number; numbers to the
right are the subchannel numbers for stations that broadcast more than one signal.
In the example to the left, press "1", press "2" (although 012 is shown in the example,
pressing "0" isn't required) and then press the right arrow button to move to the subchannel.
Press "1" and then "OK." The TV tunes to channel 12-1. If channel 12 is broadcasting
subchannel signals, you would enter numbers that would access the other signals. (Example:
12-1, 12-2, 12-3). If the selection times out, you must start over. Once you've made all entries,
press OK. The CLEAR button on the remote clears all entries.
Note: You may experience a delay of several seconds before digital pictures appear,
both when you first turn on the digital signals and when you change channels. This is
normal. Digital channels sometimes take longer to tune.
Connections & Setup
Continues on next page...
11