Download Print this page

RCA ANT3038XR User Manual page 4

Rca radio antenna user manual

Advertisement

Step 6: Connect the rear section to the middle
(large) section
Nut
Step 7: Connect the phasing lines
Phasing
line
Fig. 7
4
On the open end of the middle (large)
section, remove the rear nut and screw.
Screw
Find the rear section. Slide the narrow
boom of the rear antenna into the middle
(large) section. Tap lightly with a rubber
mallet on the end of the small boom,
aligning the holes for the screw. (See fi gure
Fig. 6
6.)
Re-install the screw and nut; be sure to
tighten securely.
On the middle (large) section, near where
the middle and rear sections come
Nut
together, fi nd the posts on the top and
Washer
bottom of the last element holder studs.
Stud
(See fi gure 7.)
Place the phasing lines from the rear
section over the studs, one on the top side
and one on the bottom. Then fasten them
to the posts with washers and #10 fl ange
nuts. Tighten securely.

Advertisement

loading