Resetting The Scanner - Radio Shack PRO-66 Owner's Manual

50-channel direct entry programmable scanner
Table of Contents

Advertisement

20-511.fm Page 37 Wednesday, August 4, 1999 2:13 PM
PROBLEM
POSSIBLE CAUSE
Poor or no recep-
tion.
Error
appears on
Programming error.
the display.
In the scan mode,
Programmed frequen-
the scanner locks
cies are the same as
on frequencies that
"birdie" frequencies.
have an unclear
transmission.

RESETTING THE SCANNER

If the scanner's display locks up or does not work properly after you con-
nect power, you might have to reset the scanner.
Caution: This procedure clears all the information you have pro-
grammed into the scanner. Before you reset the scanner, try turning it
off and on to see if it begins working properly. Use the following proce-
dure only when you are sure your scanner is not working properly.
1. Turn off the scanner.
2. While you press and hold down the
ner.
• Batteries are
• Check the batteries,
weak or dead.
• Environment is
• Relocate the scanner
not suitable for
reception by the
scanner.
• Improperly con-
• Be sure the antenna is
nected antenna.
Reprogram the frequency
correctly.
Avoid programming fre-
quencies listed under "Bird-
ie Frequencies" on
Page 29 or only listen to
them manually.
and
keys, turn on the scan-
2
9
REMEDY
or make sure the
scanner is plugged
into a working AC or
DC outlet.
and try again.
properly connected.
37

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

20-511

Table of Contents