Setting The Repeater Offset Direction; Reversing The Transmit And Receive Frequencies - Radio Shack HTX-200 Owner's Manual

SETTING THE REPEATER OFFSET
DIRECTION
1. Set an offset frequency other than 0.0.
2. Press
FUNC
above or
3. Press
FUNC
tion.
Note: To save this setting in a memory location,
flashing before you store the settings (see "" on Page 31 and
"Storing a Transmit/Receive Frequency" on Page 29). Otherwise,
the setting reverts to its saved value the next time you turn on the
HTX-200.
REVERSING THE TRANSMIT AND
RECEIVE FREQUENCIES
To swap the input and output frequencies, press
example, if you have set the radio to repeater operation on
146.940 with a positive offset, the radio would normally receive
on 146.94 and transmit on 146.340 MHz. After you press
+ the radio will receive on 146.340 and transmit on
FUNC PTT,
146.940.
This feature is useful if you want to determine whether you are
close enough to another station to communicate on a simplex fre-
quency. While the other station is transmitting, reverse the fre-
quencies. If you can still hear the other station, you are hearing
their signal directly and you do not need to use the repeater.
28
+
SC (RPT)
below).
–
+ (
MO REV
to see the current offset direction (
) to change the repeater offset direc-
must be
MR
. For
FUNC+PTT
+