OPERATION
TURNING ON THE HTX-200
To turn on the HTX-200, rotate
clockwise until it clicks.
VOL/OFF
The HTX-200 sounds a brief melody if the key tone feature is en-
abled. Then
appears for about 2 seconds and the last
HELLO
used frequency appears.
SELECTING FREQUENCIES
(DIRECT TUNING)
You tune to the desired frequencies in the VFO (variable frequen-
cy oscillator) mode. You can either step to a specific frequency or
directly select the frequency.
To step to a frequency, repeatedly press or hold down
or
until the display shows the desired frequency.
Note: The HTX-200 steps up or down in increments which you
set using the Frequency Step menu option. (See "Setting the Fre-
quency Step" on Page 39).
To directly enter a frequency, press
+
(the second digit
FUNC
from the left flashes), then press
or
to change the number.
Press
+
again to select the next digit. Repeat this to select
FUNC
each number of the desired frequency, then press
to store
PTT
the selection.
Note: The HTX-200 is preset to receive frequencies between 136
and 174 MHz, and transmit between 144 to 148 MHz. To expand
the frequency coverage, see "Changing the Transmit Frequency
Range" on Page 38.
23