Advertisement
WARNING:
To reduce the risk of fire or shock
hazard, do not expose this product to rain or
moisture.
..
..
CAUTION
!
RISK OF ELECTRIC
SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELEC-
TRIC SHOCK, DO NOT REMOVE COVER OR
BACK. NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED PERSONNEL.
The lightning symbol is intended to alert you
to the presence of uninsulated dangerous
voltage within this product’s enclosure that
might be of sufficient magnitude to consti-
tute a risk of electric shock. Do not open the
product’s case.
The exclamation symbol is intended to in-
form you that important operating and
!
maintenance instructions are included in
the literature accompanying this product.
.
.
"%#76+10"
• Do not mix battery types (Ni-Cd
and Ni-MH).
• Before connecting the charger
to AC power, be sure all
batteries are correctly
installed according to polarity,
as indicated in the battery
compartment. Incorrectly
installed batteries (polarity
reversed) will not charge and
can be damaged.
±
±
"016'"
"
• You can charge up to two AA
and two AAA batteries of the
same type in different
compartments at the same time.
• Batteries will not be damaged
by leaving them in the charger
until the timer turns it off.
R
R
"9#40+0)"
"
To prevent damage to the charger
and risk of shock, always unplug
the charger from the AC outlet
before you remove or replace the
batteries.
2
12'4#6+10
)
"%
")
'0'4#.
*#4)+0)
7+&'.+0'5
• Completely discharge Ni-Cd/Ni-MH batteries before
charging them.
• It is normal for the batteries to become warm while
. . . .
charging.
1. To charge AA batteries, insert two or four AA batteries
into the battery compartments, as indicated by the
polarity symbols (+ and –) marked inside each
compartment.
To charge AAA batteries, push down the tabs on the
top of the charger until you hear a “click”. Place two or
four AAA batteries in the battery compartment as
indicated by the polarity symbols (+ and –) marked
inside each compartment. ±
±
±
±
2. Slide the Ni-Cd/Ni-MH switch to the appropriate
position to match the type of the batteries you are
charging.
3. Lift the plug from the back of the charger and plug it into
a standard AC outlet. The indicator lights to show that
the batteries are charging.
4. When the batteries are fully charged, the red indicator
turns off. Unplug the charger from the AC outlet and
R R R R ý
remove the batteries.
%
"$
"
"&
"
*#4)+0)
#66'4+'5
9+6*
+(('4'06
%
#2#%+6+'5
The following chart shows typical charging capacities and
±
±
±
switch selections for different types and sizes of batteries.±
$CVVGT["%CRCEKV["
'UVKOCVGF"
6[RG
5K\G
*O#J+
%JCTIKPI"6KOG
AA
600
2.0 hours
AA
800
2.7 hours
Ni-Cd
AA
1000
3.3 hours
AAA
300
2.0 hours
Advertisement
