Install Infant Car Seat - Quinny Buzz Stroller User Manual

Install Infant Car Seat

WARNING
To avoid serious injury:
• Use ONLY Mico TM infant car seat (model 22371-
not included) with this stroller (model 01638).
• Please refer to the manufacturer's instructions
for the use of your infant car seat.
• ALWAYS install car seat facing to the rear of
the stroller.
• ALWAYS use the restraint system in the car
seat.
21
Install Infant Car Seat
Push the parking brake pedal down. Remove the seat.
Rotate the pivots so that the two slots are aligned
R
(Figure 21). Be sure that the pivots are in the upright
position, otherwise the adapters will not fit.
Stand at the back of the stroller. Insert the car seat
adapter labeled "R" into right side of the frame until you
hear a "click". Then insert the car seat adapter labeled
"L" into the left side of the frame until you hear a "click"
(Figure 21a).
Car seat must be in rear-facing position.
car seat into car seat adapters until both sides "click"
(Figure 21b).
To remove car seat, press both buttons on car seat
(Figure 21c). Lift car seat up.
To remove car seat adapters, press button and slide
adapter off the frame (Figure 21d).
R
Lower
21
Align Slots
21b
21d
8
21a
R
21c
TM