Precor M 9.2s Owner's Manual page 11

Diagram 3
Plug
connector
into lower
board
Ribbon cable receptacle
Ribbon cable connector
Flanged nuts (A)
Base plate
Motor chassis
Cross beam
9.
10. Align the tab on the ribbon cable connector with its counterpart located on the receptacle in
11. Have your assistants help you return the treadmill to an upright position, so that the base is
Install upper
Diagram 4
handrail
clamp
Handrail clamp
External star washers (E)
Handrail console screws (B)
Lift column
Ribbon cable
Incline crank shaft (M9.1 only)
12. Place two external star washers (E) onto two of the upper handrail console screws (B) and
13. Insert the screws (B) through the handrail clamp and into the lift column. Tighten the screws
14. Carefully route the ribbon cable through the slot on the left-hand side of the handrail clamp.
15. If your hands are dirty, wash your hands before continuing to the next step. This will help
Route the ribbon cable as shown in Diagram 3, so that you have easy access to the receptacle
on the motor chassis.
the motor chassis. Plug the connector into the receptacle. See Diagram 3. The plastic flanges
on the receptacle should clip onto the connector when you plug it in. Since the connector is
designed to engage in one direction only, do not force the connector into the receptacle.
flat on the floor.
align the upper handrail clamp with the mounting holes on the lift column. See Diagram 4.
securely with the hex key (F) provided.
Note: Right and left are determined while standing to the rear of the treadmill facing toward
the hood.
keep the electronic console display clean.
page 5