Page 1
Lea el manual del operador y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en lesiones graves. Electrolux Home Products North America Div. of WCI Outdoor Products, Inc. Augusta, GA 30907 Copyright E2000 WCI Outdoor Products, Inc. Models: 2750 2775 2900 3050 530087840 4/26/00...
S Keep fuel and oil caps, screws, and fas- teners securely tightened. S Use only Poulan accessories and re- placement parts as recommended. HANDLE FUEL WITH CAUTION S Do not smoke while handling fuel or while operating the saw.
Page 3
S Mix and pour fuel in an outdoor area on bare ground; store fuel in a cool, dry, well ventilated place; and use an approved, marked container for all fuel purposes. Wipe up all fuel spills before starting saw. S Move at least 10 feet (3 meters) from fuel- ing site before starting engine.
MAINTAIN CONTROL Stand to the left of the saw Never reverse hand positions Elbow locked Thumb on under side of handlebar S Keep a good, firm grip on the saw with both hands when the engine is running and don’t let go. A firm grip will help you reduce kickback and maintain control of the saw.
SAFETY NOTICE: Exposure to vibra- tions through prolonged use of gasoline powered hand tools could cause blood ves- sel or nerve damage in the fingers, hands, and joints of people prone to circulation dis- orders or abnormal swellings. prolonged use in cold weather has been linked to blood ves- sel damage in otherwise healthy people.
2-cycle air-cooled engine oil. recommend Poulan Poulan ProR brand oil. If you do not use this oil, use a good quality 2-cycle air-cooled oil designed to be mixed at a ratio of 40:1 (A 40:1 ratio is obtained by mixing 3.2 onces of oil with 1...
Poulan Poulan Pro oil resists high temperature thinning. If Poulan Poulan Pro bar and chain oil is not available, use a good grade SAE 30 oil. S Never use waste oil for bar and chain lu- brication. S Always stop the engine before removing the oil cap.
S Keep the chain out of dirt and sand. Even a small amount of dirt will quickly dull a chain and thus increase the possibility of kickback. S Practice cutting a few small logs using the following technique to get the “feel” of using your saw before you begin a major sawing operation.
Page 9
Hinge holds tree on stump and helps control fall Opening of felling Closing of notch NOTE: Before felling cut is complete, use wedges to open the cut when necessary to control the direction of fall. Use wood or plastic wedges, but never steel or iron, to avoid kickback and chain damage.
Using a log for support Using a log for support Using a support stand Using a support stand REMOVING A PINCHED SAW (A SAW HUNG IN THE LOG) S If saw becomes pinched or hung in a log, don’t try to force it out. You can lose con- trol of the saw resulting in injury and/or damage to the saw.
Page 11
S Limit pruning to limbs shoulder height or below. Do not cut if branches are higher than your shoulder. Get a professional to do the job. Make your fist cut 1/3 of the way through the bottom of the limb. Next make a 2nd cut all the way through the limb.
ELECTROLUX HOME PRODUCTS NORTH AMERICA, Division of WCI Outdoor Prod- ucts, Inc., warrants to the original purchaser that each new Poulan Poulan PRO brand gasoline chain saw is free from defects in ma- terial and workmanship and agrees to repair or...
Page 13
WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGA- TIONS: The U. S. Environmental Protection Agency and POULAN/WEED EATER, DIVI- SION OF WCI OUTDOOR PRODUCTS pleased to explain the emissions control sys- tem warranty on your lawn and garden equip- ment engine. All new utility and lawn and gar-...