Troubleshooting - Polaroid DRA-01601A User Manual

Troubleshooting Guide
Before contacting service personnel, please check possible problems and solutions below:
S
YMPTOM
No power
No sound
No picture
No color
Disc cannot be played
Remote control malfunction
Sudden malfunction
Picture dividing
External signals cannot be recorded
No monitor signal
Timer recording cannot be done
Recording aborted halfway
P C
OSSIBLE AUSE
1. Power supply disconnected
2. Bad connection between power
plug and receptacle
3. Power of receptacle switched off
1. Incorrect input connection
2. Disc is deformed or dirty
3. System is in mute status
1. Incorrect signal connection
2. Incorrect TV status
3. TV system out mode is
Progressive, but your TV system
is Interlace mode
1. Wrong TV system selection
2. Improper color adjustment
3. Incorrect video output
1. No disc in drive
2. Disc placed incorrectly
3. Moisture condensed in unit
4. Not in playing status
5. Wrong disc format
6. Disc dirty
1. Remote control not directed at
sensor
2. Receiving distance is more than 8
meters
3. Low voltage in remote control
batteries
4. Outside obstacle between unit and
remote control
1. Bad disc quality
2. Button was pressed mistakenly
3. Outside static
1. Selected system is incompatible
with disc
1. Incorrect system connection
2. No disc or re-recordable disc
3. Disc has been fi nished
4. No free disc space
1. Input source not prepared
2. Incorrect video output system
3. Actual input source not consistent
with selected
1. Disc does not meet requirements
2. Wrong time setting
3. Input source does not work
properly during recording time
4. System power failure
1. There is no free disc space
2. Bad disc quality
33
R
EMEDY
1. Connect to power supply
2. Plug again or replace receptacle
with new one
3. Switch on receptacle
1. Connect inputs properly
2. Clean of fi x disc
3. Press "MUTE" button
1. Connect the inputs correctly
2. Re-adjust TV/AV status
3. Press PS/IS to angle or mode
1. Set up system by pressing
"SYSTEM" button on remote control
2. Readjust color
3. Check for correct video output
settings
1. Insert disc
2. Put disc on disc tray properly with
label side up
3. Leave unit on for about an hour
(without disc) before using again
4. Press "PLAY" button to switch
playing status
5. Please with supported disc format
6. Clean disc with soft cloth from
center to edge
1. Direct remote control at sensor
2. Reduce receiving distance
3. Replace batteries
4. Remove obstacle
1. Wait 5-10 seconds, playback will be
restored
2. Turn off and restart unit
3. Shut off for 1-2 minutes and restart
unit
1. Set up correct system
1. Connect properly
2. Insert recordable disc
3. Change disc
4. Change disc
1. Prepare input source
2. Switch video output system
3. Select proper input source
1. Replace with new disc
2. Set up time again
3. Ensure input source works correctly
during recording time
4. Set system to standby
1. Replace with blank disc
2. Replace with high quality disc