Transporting The Atv - Polaris Magnum 330 Owner's Manual

MAINTENANCE AND LUBRICATION
Cleaning and Storage
Storage Tips
Battery Storage
Conventional Battery: Remove the battery and add distilled water to
the proper level. Do not use tap water, which may contain minerals
that reduce battery life. Apply Polaris di-electric grease to the terminal
bolts and terminals. Charge the battery at 1.4 amps or less until the
specific gravity of each cell is 1.265 or greater. While the battery is in
storage, check the fluid level once a month.
Sealed Battery: Remove the battery and ensure that it's fully charged.
See page 135 for instructions.
Both battery types should be stored in a cool, dry place. Battery charge
can be maintained easily by using Polaris Battery Tendert charger
(PN 2871076) or by charging about once a month to make up for
normal self-discharge. Battery Tendert can be left connected during
the storage period, and will automatically charge the battery if the
voltage drops below a pre-determined point.
Engine Anti-Freeze
Test engine coolant strength and change if necessary. Coolant should
be replaced every two years.
Storage Area/Covers
Set the tire pressure and safely support the ATV with the tires 1-2" off
the ground. Be sure the storage area is well ventilated, and cover the
machine with a genuine Polaris ATV cover. NOTE: Do not use plastic
or coated materials. They do not allow enough ventilation to prevent
condensation, and may promote corrosion and oxidation.

Transporting the ATV

Follow these procedures when transporting the vehicle.
1. Turn off the engine and remove the key to prevent loss during
transporting.
2. Turn the fuel valve off.
3. Be sure the fuel cap, oil cap and seat are installed correctly.
4. Always tie the frame of the ATV to the transporting unit securely
using suitable straps or rope.
5. Always place the transmission in gear and lock the parking brake.
140