Step 3 - Connecting The Monitor - Planar Touch Monitor LX1200TI User Manual

Step 3 - Connecting the Monitor

Once the LX1200TI is mounted in place, connect it to the computer (or other
video source) and the 12 VDC power supply as follows.
Note: This procedure refers to connections to and from the computer.
However, depending on your particular hardware confi guration, these
connections may be to a dock or other device rather than directly to
the computer.
1. As needed, route any data and power cables from the computer to the
monitor.
2. Make sure the computer is turned off .
3. Connect the 12 VDC power supply cable to the monitor's power supply.
Note: Use a 5-Amp fuse in line to the power source.
Also, to prevent vehicle battery from draining, you should install a
device that shuts off power to the monitor while the monitor is
inactive. (An example is Lind Electronic's Vehicle Battery Voltage
Shutdown Timer - www.lindeletronic.com).
4. Connect the power supply and power interrupt cables (for the
All-in-One power switch, if your computer or docking station is so
equipped) to the connectors on the bottom of the monitor. See the
following diagram for connector locations.
Speaker Vent
USB Type A
USB Type B Upstream
Volume Dial
VGA
Power 12 V
USB Type A
Dimming Dial
Remote PC Shutdown
LX1200TI User's Guide (020-0512-01A)
Audio
17