5 minute guide
5
Follow the instructions on-screen.
• Make sure the microphone is connected.
• If you're using a subwoofer, it is
automatically detected every time you
switch on the system. Make sure it is on
and the volume is turned up.
• See below for notes regarding background
noise and other possible interference.
6
Wait for the test tones to finish.
A progress report is displayed on-screen while
the receiver outputs test tones to determine the
speakers present in your setup. Try to be as
quiet as possible while it's doing this.
1.Auto MCACC
Now Analyzing
Environment Check
Ambient Noise
Microphone
Speaker YES/NO
• For correct speaker settings, do not adjust
the volume during the test tones.
7
Confirm the speaker configuration.
The configuration shown on-screen should
reflect the actual speakers you have.
1.Auto MCACC
Check!
Front
Center
Surround
SUB W.
30:Next
If the speaker configuration displayed isn't
correct, use
to select the speaker and
to change the setting. When you're
finished, go to the next step.
Note
1 • Depending on the characteristics of your room, sometimes identical speakers with cone sizes of around 12 cm (5 inches)
will end up with different size settings. You can correct the setting manually using the Speaker Setting on page 42.
• The subwoofer distance setting may be farther than the actual distance from the listening position. This setting should be
accurate (taking delay and room characteristics into account) and generally does not need to be changed.
[ O K ]
[
O K
]
[
]
OK
:Cancel
[ YES ]
[ YES ]
[ YES ]
[ YES ]
OK
:Cancel
If you see an error message (ERR) in the right
side column, there may be a problem with the
speaker connection. If selecting RETRY
doesn't fix the problem, turn off the power and
check the speaker connections.
8
Make sure 'OK' is selected, then press
ENTER.
If the screen in step 7 is left untouched for 30
seconds and the ENTER button is not pressed
in step 8, the Auto MCACC setup will start
automatically as shown below.
A progress report is displayed on-screen while
the receiver outputs more test tones to
determine the optimum receiver settings for
channel level, speaker distance, and Acoustic
Calibration EQ.
1.Auto MCACC
Now Analyzing
Surround Analyzing
Speaker System
Speaker Distance [
Channel Level
Acoustic Cal EQ
Again, try to be as quiet as possible while this
is happening. It may take 3 to 8 minutes.
9
The Auto MCACC Setup has finished!
Select 'SKIP' to go back to the System
Setup menu.
The MCACC indicator on the front panel will
light to show the setup is complete.
The settings made in the Auto MCACC Setup
should give you excellent surround sound
from your system, but it is also possible to
adjust these settings manually using the
System Setup menu (starting on page 37).
02
[
]
]
[
]
[
]
:Cancel
1
9
En
Comments to this Manuals
Latest comments: