Troubleshooting - Philips DECT baby monitor SCD487 User Manual

Problem
LINK light (A-2, B-8)
does not light at all.
LINK light (A2, B-8)
flashing red/alarm
beeping on parent unit.
Possible cause
Parent unit:
Power adapter (B-14) not
plugged in.
Unit not turned on.
Batteries are low.
Baby unit:
Power adapter (A-11) not
plugged in.
Batteries incorrectly inserted.
Unit not turned on.
Batteries are low.
Units out of range.
Batteries are low.
Units cannot establish
connection, even when close
to each other.
No power on one of the units.

Troubleshooting

Solution
Connect power adapter (B-14)
to parent unit.
Connect power adapter (B-14)
to wall outlet.
Press and hold On/Off button (y)
(B-6) for two seconds.
Replace batteries (B-12).
Connect power adapter (A-11) to
baby unit.
Connect power adapter (A-11) to
wall outlet.
Insert batteries correctly.
Press and hold On/Off button (y)
(A-1) for two seconds.
Replace batteries (A-9).
Decrease distance between units
(see 'Technical specifications).
Replace batteries (A-9, B-12).
Try solving the problem by using
the factory initialization mode.
See chapter 'Factory initialization
mode'.
Press On/Off button (A-1, B-6)
for two seconds.
EN
13