Philips FW-M355 Manual page 30

Troubleshooting
GENERAL
The system does not react when
buttons are pressed.
Sound cannot be heard or is of poor
quality.
The left and right sound outputs are
reversed.
The remote control does not function
properly.
The timer is not working.
Not all lighted buttons are showing light.
The Clock/Timer setting is erased.
The system displays features
automatically.
30
pg 001-030/M355/22-Eng
– Remove and reconnect the AC power plug and
switch on the system again.
– Adjust the volume.
– Disconnect the headphones.
– Check that the speakers are connected correctly.
– Check if the stripped speaker wire is clamped.
– Make sure the MP3-CD was recorded within
32-256 kbps bit rate with sampling frequencies
at 48 kHz, 44.1 kHz or 32 kHz.
– Check the speaker connections and location.
– Select the source (CD 1/2/3 or TUNER, for
example) before pressing the function button
(É,í,ë).
– Reduce the distance between the remote
control and the system.
– Insert the batteries with their polarities
(+/– signs) aligned as indicated.
– Replace the batteries.
– Point the remote control directly towards the IR
sensor .
– Set the clock correctly.
– Press and hold CLOCK•TIMER to switch on the
timer.
– If recording or tape dubbing is in progress, stop
recording.
– Press DIM to select DIM OFF display mode.
– Power has been interrupted or the power cord
has been disconnected. Reset the clock/timer.
– Press and hold Çon the system to switch off
the demonstration.
30
3139 115 21422
4/17/02, 10:37 AM