Troubleshooting - Philips DVDR3455H User Manual

Troubleshooting

WARNING
Under no circumstances should you try to repair the system yourself, as this
will invalidate the warranty. Do not open the system as there is a risk of
electric shock.
If a fault occurs, fi rst check the points listed below before taking the system for
repair. If you are unable to remedy a problem by following these hints, consult
your dealer or Philips for help.
Problem (General)
No power.
The recorder does not
respond.
Remote control does not
work.
No picture.
No sound.
No TV signal received from
the recorder.
76
– Press STANDBY-ON key on the front of the recorder to turn
on the system.
– Make sure the AC outlet has power.
– There is a technical problem. Disconnect the recorder from the
power outlet for 30 seconds, then reconnect and switch on the
recorder again..
– Aim the remote control directly at the iR sensor on the front of
the recorder (not towards TV).
– Remove any obstacles between the recorder and remote
control.
– Batteries are weak, replace the batteries.
– Turn on your TV and set to the correct Video In channel for
the recorder. You may go to Channel 1 on your TV, then press
the channel down key on your TV's remote control until you
see the TV program.
– Check the video connection between the recorder and the TV.
– Check the recorder audio connections. Read chapter "Basic
Recorder Connections - Connecting the audio cables" for
details.
– Set the option for digital audio output correctly, based on the
device you have connected to the recorder. Read chapter
"Setup Menu Options - AUDIO settings" for details.
– Have your antenna or cable TV signal checked.
– Install the TV channel. Read chapter "Installation and Setup -
Setting your TV channel programs" for details.
Solution