Battery Installation - Audiovox FR548-2CH Owner's Manual

BATTERY INSTALLATION

Your FR548-2CH requires four AAA alkaline or four
rechargeable AAA cells. Alkaline batteries will pro-
vide the best performance from your transceiver.
Remove the battery cover by releasing the clip latch
at the top, and sliding the clip up and away from the
back of the unit. Slide the battery cover downward
while applying pressure at the embossed arrow.
Observe the polarity symbols inside the battery tray
when installing the batteries.
WHEN TO USE THE CHARGING ADAPTER KIT
The Battery Charging Adapter Kit consists of an AC Wall Adapter/Charging Trans-
former and a Desk-Top Charging Stand; it can be used only if the FRS radio is
equipped with four rechargeable 1.2 Volt, 600mAh Audiovox Nickel Metal hydride
rechargable batteries (P/N: ABC6CF1).
Charging the FR548-2CH:
Insert the charging transformer into a household electrical outlet and connect its
power jack to the PWR socket on the rear of the charging stand. Simply placing
the unit into the charging stand will begin the charging process. The red LED on
the front of the charging transformer serves as a charge indicator. The charging
stand will charge two units simultaneously. Approximately 12-16 hours are required
to fully charge the batteries. Remember to turn your FR548-2CH OFF before
placing it into the charging stand.
CAUTION: The charging stand in your kit is intended for use with the
supplied batteries. Do not attempt to recharge any other
batteries with the charging stand.
EMBOSSED
CLIP
ARROW
RELEASE
LATCH
BATTERY
COVER
-8-
128-6282A
8 of 16