5
Connect the mains jack 4
Recorder with the power supply using the supplied power cable.
The most important features of the DVD Recorder will appear
on the display.
After the initial installation is completed, this function will be
switched off. How you switch on this function again, read in the
chapter 'User preferences' in the section 'Standby'.
6
Press
appear on the display.
7
Switch on your TV and select the channel used for DVD/VCR
playback on your TV. Choose between channel 3 or 4.
The factory setting is for channel 3. However, if you would like to
switch to channel 4, proceed as follows:
1
Hold
on the remote control while '
2
'
' (channel 4) will appear on the display.
If you want to switch back to channel 3, hold
3
will appear on the display.
After the installation you can switch between the channels only
4
during standby.
8
Switch your TV to the selected channel (channel 3 or 4). Use
therefore your TV remote control.
The menu for language selection will appear on the screen.
a
b Check the cable connections.
b Change between channel 3 and 4 on the TV.
9
This TV channel number must be used in the future for DVD
Recorder playback.
Then, read the paragraph 'Initial installation' in the chapter 'Installing your DVD Recorder'.
at the back of the DVD
m on the recorder. '
' is displayed.
. '
' will
' (channel 3)
Connecting the DVD Recorder