Connecting To Your Computer; Via Usb Cable - Pentax PocketJet 3 User Manual

Connecting to Your Computer

There are two ways to connect your PocketJet to your computer,
via USB cable and via Infrared (IrDA).

Via USB Cable

CAUTION: Install the driver software before connecting the printer
1. Make sure your printer is off before installing the interface cable.
2. Take the printer end of the cable and hold it so the notched metal
surface is facing up.
3. Insert the printer end of the cable into the interface connector on the
side of the printer. See example, Figure 7
FIGURE 7. Connecting the PocketJet to your computer
CAUTION: Always insert and remove the interface connector
4. Connect the other end of the cable to the USB port on your
computer.
Note 1: USB is not supported for Windows 95.
Note 2: For Windows 98/98-SE, USB printing requires installing Microsoft's
USBPRINT solution. To install this software:
A. Connect the USB cable to the printer and computer.
B. The Windows Add Hardware Wizard window will open (if it does not
open, the software has already been installed). Choose "Specify a
to the computer via the USB cable.
gently. Press the latching devices on each side of the
interface connector when removing the cable.
Page 23