Sign in today to find solutions:

Don't have an account? Sign up

Pelco ENDURA WS5000 Instructions Manual

Pelco home security system user manual.

 
®
Endura
WS5000
Software Recovery
Instructions
Video Security System
C1677M (7/05)
Next page ->

Summary of Contents

  • Page 1

    ® Endura ™ WS5000 Software Recovery Instructions Video Security System C1677M (7/05)

  • Page 2

    The Windows XP operating system becomes corrupted and you cannot access the boot image. Pelco provides several methods for restoring the workstation to full operation. To restore only the WS5000 software, use the built-in Re-install WS5000 utility to restore it on the workstation. To restore Windows XP when it is damaged but the workstation will start, use the bootable image located on the disk drive to restore Windows XP.

  • Page 3

    Recovering the WS5000 Software Follow these instructions if Microsoft Windows is still operable on the workstation but the WS5000 software fails to start properly. 1. If you are logged on as a user, close all programs and log out. NOTE: It is not enough to switch users to the WS5050 Administrator. You must log out and then log back on as the WS5050 Administrator. 2.

  • Page 4

    No further configuration is required when you recover Windows XP from the factory default image that is stored on the hard disk. To start the workstation in Recovery Mode manually: 1. Restart the workstation. The Pelco logo screen appears. 2. When a blinking cursor appears in the upper left-hand corner, press the Esc key. The Extended Operating System Loader screen appears.

  • Page 5

    Click, “No, I don’t want to register now; let’s just activate Windows,” and then click Next. It is not necessary to register Windows XP. Pelco registered the software for you when you purchased the WS5050 workstation. The wizard activates the software and displays the following message: “You have successfully activated your copy of Windows.”...

  • Page 6

    Click, “No, I don’t want to register now; let’s just activate Windows,” and then click Next. It is not necessary to register Windows XP. Pelco registered the software for you when you purchased the WS5050 workstation. The wizard activates the software and displays the following message: “You have successfully activated your copy of Windows.”...

  • Page 7

    California. Repairs made necessary by reason of misuse, alteration, normal wear, or accident are not covered under this warranty. Pelco assumes no risk and shall be subject to no liability for damages or loss resulting from the specific use or application made of the Products. Pelco’s liability for any claim, whether...

  • Page 8

    Worldwide Headquarters 3500 Pelco Way Clovis, California 93612 USA USA & Canada Tel: 800/289-9100 Fax: 800/289-9150 International Tel: 1-559/292-1981 Fax: 1-559/348-1120 www.pelco.com ISO9001 United States Canada United Kingdom The Netherlands Singapore Spain Scandinavia France Middle East...

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: