Advertisement
LINE CORD (17)
(120V products only)
For your safety, we have incorporated a 3-wire line (mains) cable with proper grounding facilities. It is not advisable to
remove the ground pin under any circumstances. If it is necessary to use the equipment without proper grounding
facilities, suitable grounding adaptors should be used. Less noise and greatly reduced shock hazard exists when the unit
is operated with the proper grounded receptacles.
SPEAKER JACK (18)
Provided for connection of internal and/or external speakers. Minimum total impedance is 4 ohms.
BALANCED LINE OUT (19)
Provides 600 ohm, transformer balanced signal to be used as "direct" patch into mixing consoles, tape recorders, etc. The
signal at this point has been frequency compensated for low noise operation.
PREAMP OUT/POWER AMP IN (20)
These jacks are provided for in-line patching of effects devices. To patch an effects unit, connect the Preamp Output to the
Input of the device. Next, connect the output of the device to the Power Amp Input (high-quality shielded cables must be
used for these connections). The Preamp Output can also be used to route the amplified signal to a mixing console, tape
recorder, etc. Connect the Preamp Output, using a shielded cable, to an input of the tape recorder, mixer, etc. This patch
does not affect the operation of the amplifier. NOTE: The preamp output level is approximately 1 volt RMS and is of
relatively low impedance (600 ohms). Any effects device used in this effects loop must be capable of receiving 1 volt input
and providing 1 volt output in order to properly drive the power amp. The Power Amp Input has an internal switch which
disconnects the internal preamp.
FOOTSWITCH JACK (21)
Provided for connection of the supplied remote footswitch. Footswitch is used to defeat reverb, post effects loop 1, and
post effects loop 2.
Effects Device or Volume Pedal
Session 400
Effects Device
Shielded Cables Must Be Used
600 ohm balanced out to mixer,
tape deck, etc. (frequency compensated)
LINE LEVEL EFFECTS DEVICE
EFFECTS PATCH
Effects Device
Shielded Cables Must Be Used
0
0
Advertisement
