Download Print this page
Peavey PRO COMM V12 Operating Manual
Peavey PRO COMM V12 Operating Manual

Peavey PRO COMM V12 Operating Manual

True diversity vhf wireless receiver

Advertisement

Quick Links

Pro Comm
True Diversity VHF Wireless Receiver
PCX
-V12
®
Operat
Operating
Manu
Manual
www.peavey.com
www.peavey.com

Advertisement

loading

Summary of Contents for Peavey PRO COMM V12

  • Page 1 Pro Comm ® True Diversity VHF Wireless Receiver www.peavey.com www.peavey.com -V12 ™ Operat Operating Manu Manual...
  • Page 3 If your system is FCC Class B, the following applies: Note – These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
  • Page 4 Duración por Día en Horas Nivel de Sonido dBA, Respuesta Lenta 1 1 /2 1 /2 1 /4 o menos...
  • Page 7 ENGLISH...
  • Page 10 Figure 1 Plug Patterns Available: 120V North American 60 Hz Nema 5-15 NOTICE: Use the correct plug pattern for your area. If you 240 United Kingdom acquired the 50 Hz wrong plug, return unit to place of purchase. 220 Europlug 50 Hz CEE 7/16...
  • Page 11 PIN 2 GND PIN 1 PIN 3...
  • Page 13 IV Operation Instructions Squelch control...
  • Page 15 Caution...
  • Page 16 V. Handheld Wireless Microphone I. Unit Features and Functions 1. Grille: Protects cartridge and prevents breathing and wind POP noises. 2. Housing: Upper portion that is connected to the capsule module. Internally it holds the transmitter PCB and battery compartment. 3.
  • Page 17: Battery Insertion

    II. BATTERY INSERTION III. OPERATING INSTRUCTIONS...
  • Page 18 Belt Pack Transmitter GAIN I. Unit Features and Functions 1. 3-pin Jack Input Connector: Connects to the Peavey ® Pro Comm 3-pin connector. Allow 5 different input configurations (See the five ways of connection on an AF input connection, page 20.) 2.
  • Page 19 4. Gain Control: Adjusts the input gain to an appropriate level. 5. Transmitter Housing: Contains the PCB and battery. 6. Battery Status Indicator: battery status. 7. Power Switch: Switch to ON position for operation. Switch to OFF position when not in use. 8.
  • Page 20 HEADSET LAVALIER III. AF 4-Pin Input Connection Methods CAPSULE CONNECTOR PLEASE AIM AT THE FILISTER AND INSERT THE CONNECTOR SHIELD AUDIO SHIELD AUDIO SHIELD AUDIO 4 PIN PLUG 4 PIN PLUG 4 PIN PLUG...
  • Page 21 SPECIFICATIONS 1. Overall: VHF PCX-V12 > > < 2. Receiver: VHF PCX-V12 SHIELD AUDIO SHIELD AUDIO > > > 4 PIN PLUG 4 PIN PLUG...
  • Page 22: Troubleshooting Guide

    3. Transmitter: VHF PCX-V12 < TROUBLESHOOTING GUIDE Symptom Distance No AF signal and no RF signal No AF signal and no long RF signal No AF signal but normal RF signal Distortion with no AF peak indication Noise with low AF signal and normal RF signal Intermittent AF signal...
  • Page 23 Logo referenced in Directive 2002/96/EC Annex IV (OJ(L)37/38,13.02.03 and defined in EN 50419: 2005 The bar is the symbol for marking of new waste and is applied only to equipment manufactured after 13 August 2005...
  • Page 24 Features and specifications subject to change without notice. Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305 (601) 483-5365 • FAX (601) 486-1278 • www.peavey.com • ©2011 • EX000045...

This manual is also suitable for:

Pro comm pcx-v12