ParaBody 425 Assembly Instructions Manual page 13

S~ep 1 1
A.
Pre-ossemble the PEC SEAT (21), using the following steps:
~ SECURELY ossemble one of the BACK/SEAT PADS (.55) fo the PEC SEAT (21), using two
X 5 IN. BOLTS (75), two 5/8 IN. LOCK WASHERS (70), and two 5/8 iN. WASHERS (69).
~ Assemble two ROLLER PADS (50)
fo the PEC SEAT (21) as shown on draw;ng, using one ROLLER
PAD SHAFT (55), and two 9/16 MUSHROOM CAPS
B. Attach eight PARAGLIDE STRIPS (50) to the FRONT UPRIGHT (22) using the following steps:
* Thoroughly clean all surfaces where the PARAGLIDE STRIPS (50) are to be attached.
~ Remove the PARAGLIDE STRIPS from the paper backing
and firmly apply them to surfaces.
C.
Pull beck the SPRING PIN (49) on the FRONT UPRIGHT (22) and insert the PEC SEAT (21) down
desired height. Release the SPRING PIN (49) and allow if to engage into the adiusfment holes. Use
the THUMB SCREW (46) to tighten the PEC SEAT (21) in place.
Attach eight PARAGLIDE STRIPS (50) to the ADJUSTABLE ROLLER PAD SLEEVE (24) as shown,
and using the following steps:
¯ Thoroughly clean all surfaces where the PARAGLIDE STRIPS are to be attached.
¯ Remove the PARAGLIDE STRIPS (50) from the paper backing and firmly apply them to surfaces.
t4