ParaBody 425 Assembly Instructions Manual page 12

(CONTINUED FROM PAGE 12..)
C.
SECURELY assemble the WEIGHT STACK SHAFT (104) fo the HEAD PLATE (105) as shown on drawing,
using one 5/B X 1 IN. BUTTON HEAD CAP SCREW (78) and one 5/8 IN. BLACK LOCK WASHER (77).
D.
Shop two WEIGHT PLATE BUSHINGS (107) each, into fifteen WEIGHT PLATES (105) as shown.
ASSEMBLING A 200 LB. STACK AT THIS TIME, SNAP TWO WEIGHT PLATE BUSHINGS (107)
EACH INTO THE REMAINING FIVE WEIGHT PLATES (105)).
E.
USING EXTREME CARE slide all fifteen (or twenty) WEIGHT PLATES (105) down over the OUIDE
RODS (27) onto the WEIGHT STACK CUSHIONS (59) as shown on drawing. (MAKE SURE THAT
KEY HOLES OF THE WEIGHT PLATES ARE ALL FACING THE SAME WAY)
F. Slide the HEAD PLATE ASSEMBLY down over the GUIDE RODS (27) onto the WEIGHT STACK as shown
on drawing.
G. Swing the OUIDE RODS (27) under the TOP BOOM (5) as shown on drawing, and hold in place with
NYLON BOLTS (44).
G.
Attach the WEIGHT STACK LABELS (101) to the WEIGHT STACK as shown on drawing. Also insert the
WEIGHT STACK SELECTOR PIN (58) into the first WEIGHT PLATE (105) of the WEIGHT STACK.
Step 1 0
SECURELY assemble one .5/8 IN. SPRING PIN
ASSEMBLY (49) to the SPRING PIN HOUSING,
of the FRONT UPRIGHT (22) us shown.
(!!! IMPORTANT !!! TIGHTEN THE NUT OF
THE SPRING PIN ASSEMBLY SECURELY)
B. Attach one THUMBSCREW (46) fo the
FRONT UPRIGHT (22) as shown on drawing.
Assemble two ROLLER PADS (50) fo the
FRONT UPRIGHT (22) using one ROLLER PAD
SHAFT (35), and two 9/16 MUSHROOM
CAPS (52).
1/2 i 1/2 I
1/2 I 1/2 I 1/2
I I
1 2
3
4
5 6
, I I I I I I ! I I
13