Panasonic PMCH8 Product Instructions

Manufactured by:
Before attempting to connect or operate this product, please read these instructions completely.
MODEL: Indoor Wall/Corner/Ceiling Housings
PMWH8, PMCH8
STANDARD INSTALLATION PROCEDURE
INCLUDES MODELS: PMWH8, PMCH8
NOTE: Max. storage space is 8"
(Panasonic 1/3" Camera Class with
Panasonic Fixed Focal Lens Series)
1. Remove contents from carton and open lid of the unit with barrel
lock key. Note : key is removable only when lid is locked; see
Figure 1 .
2. To access inside of the unit during mounting and adjusting the lid
can be temporarily propped open by using a screwdriver or similar
object in the manner shown in Figure 2 .
3. Position unit in desired location and mark spots of the four
mounting holes. For best results, use the actual housing to obtain
placements of mounting holes. The hole location diagrams are
for general references only.
4. Prepare spots marked on mounting surfaces as required by
applicable building codes before mounting the unit.
5. Pass electrical and video cables through the access hole on back
of the unit, or use any of the knockout hole(s), then secure unit in
place with appropriate hardware.
6. Complete electrical and video connections with camera before
attaching camera to camera bracket with the hex bolt.
Use with Class 2 power supply only.
7. To achieve desired camera position, adjust hex bolt and slotted
screw with proper tools. Figure 3 shows the three directions in
which the camera & the bracket can be maneuvered. Note : place
lens of the camera as close to viewing window as possible so as
to provide adequate room in the back for cables & connectors. In
addition, the use of a right angle coax connector is strongly
recommended as it greatly reduces strain on coax cable connection
with camera.
8. After tightening all fasteners close and lock the lid to complete the
installation.
DO NOT EXPOSE ENCLOSURE TO RAIN OR MOISTURE
for
FIG. 1
FIG. 2
Note :
!
FIG. 3
PRODUCT INSTRUCTIONS
Open
81-IN3034-9922
Lock and
remove key