Panasonic PCF2 Product Instructions

Manufactured by:
Before attempting to connect or operate this product, please read these instructions completely.
MODEL: Miniature Camera
PCF2, PCV2, PCF6, PCV6,
PCF6W, PCV6W
DESCRIPTION: Dome Housing, Color Camera - PCF2, PCV2
Pendant Mount Dome Housing, Color Camera - PCF6, PCV6
Wall Mount Dome Housing, Color Camera - PCF6W, PCV6W
STANDARD INSTALLATION PROCEDURE
CONTENTS INCLUDE:
(1) Dome base
(1) Dome
(1) Dome liner
(1) Camera swivel plate
(1) Camera mount with camera, lens, and PC Board
(1) Camera adjustment arm
(1) Camera adjustment template
(2) 4-40 x 1/4" screws
(1) 8-32 x 3/8" screw
INSTALLATION
1. Locate the area on the ceiling or wall where the housing is
to be mounted. Cut a hole no larger than 2 1/4" in diam-
eter and feed the necessary wires/cable through the hole.
2. Remove the dome and liner by turning the dome counter-
clockwise and gently pulling down.
3. Place the dome base against the ceiling/wall, with the
cutout in the center, and mark the keyhole slots. Insert a
screw on each mark and tighten down 3/4 of the length
of the screw.
4. Feed the wires/cable through the hole in the dome base.
5. Place the keyhole slots in the base over the screws and
slide forwared so that the screws hold the base to the sur-
face. Tighten the screws.
Dome Tab Slots
Dome Tab Slots
for
Wire or Cable Entry
Wire or Cable Entry
Key Hole
Key Hole Slots
Slots
PRODUCT INSTRUCTIONS
ATTACHING HOUSING (PCF6/PCV6 PENDANT MOUNT)
1. Install 3/4" EMT pipe (not provided) to the desired length.
2. Slide the top dome 10" to 12" onto the pipe, leaving enough
room to work. Run the wiring through the EMT connector
and wiring hole inside the top of the housing.
3. Slide complete unit onto the pipe. Tighten the set screw
when
in place.
4. Once the housing is secured to the pipe, slide the top dome
down onto the top of the housing.
EMT Clamp
Connector
NOTE: Once the housing has been attached to the desired
location, connect the power and video wires as
required.
!
Connect Class 2 power supply only!
81-IN3047-9922
3/4" EMT Pipe
(not provided)
Top Dome
Housing
Liner
Dome