Option Menu; Input Guide; Osd Design; Osd Position - Panasonic PT-AX200E Operating Instructions Manual

OPTION menu

Remote control
See "Navigating through the MENU" on page 27.
See "Main menu and sub-menu" on page 28.

INPUT GUIDE

When you change the input method, the guidance
appears in the upper right corner of the screen. The
following display methods are available. Press I H to
cycle through the options.
Options
OFF Turn off the guidance.
Display the input method by text. The
SIMPLE INPUT GUIDE will go out after
5 seconds without any operation.
Display the input method by graphic. The
DETAILED INPUT GUIDE will go out after
10 seconds without any operation.

OSD DESIGN

You can change the background colour of the menu.
Press I H to cycle through the option.
TYPE1
TYPE2
TYPE3

OSD POSITION

You can change the position where to display the menu.
Press I H to cycle through the options.
UPPER
LEFT
LOWER
LEFT
E
38 - NGLISH
Control panel
Function
Semi transparent black
Solid blue
Semi transparent dark blue
UPPER UPPER
CENTRE RIGHT
CENTRE
LOWER LOWER
CENTRE RIGHT

BACK COLOUR

You can choose a screen colour from BLUE or BLACK
for when the projector is idle. Press I H to select.

STARTUP LOGO

You can switch the logo on/off that is displayed when
starting up the projector. Press I H to select the
required option. STARTUP LOGO will be displayed for
30 seconds.
ON Active
OFF Deactive

AUTO SEARCH

When the projector is turned on, the input terminals are
detected and an input signal is selected automatically.
You can switch the system on/off. Press I H to cycle
through the options.
ON Active
OFF Deactive
NOTE:
• When no signal is detected, the last used input will be
selected.

HDMI SIGNAL LEVEL

When an HDMI is not projected normally, you can switch
the HDMI signal level to NORMAL or EXPAND. Press I
H to select an option.
NORMAL General HDMI signal level
EXPAND Expanded HDMI signal level
NOTE:
• HDMI SIGNAL LEVEL is not available with some
equipment.

INSTALLATION

When installing the projector, select the projection
method according to the projector position. Press I H
to cycle through the options. See "Projection method" on
page 15.
Setting on a desk/floor and
FRONT/DESK
projecting from front
Mounting in the ceiling and
FRONT/CEILING
projecting from front
Setting on a desk/floor and
REAR/DESK
projecting from rear
Mounting in the ceiling and
REAR/CEILING
projecting from rear