Panasonic AG-MX70 Operating Instructions Manual page 22

[INTVideo] internal video setting screen
When [Memory] has been selected
Described below are the write and preview procedures for "Still" (still picture) or "Movie" (moving picture). It is possible to set
the number of frames (number of pages) that can be used to a maximum of 30 (NTSC) or 26 (PAL). However, if pages are
allocated to titles, the number of pages will be reduced by the equivalent amount. The page allocation can be changed on
the "Setup" initial setting screen.
≥ Write procedure
Use the rotary 5 control to set the mode to "Write."
Use the rotary 2 control to select the page on which the
images are to be written.
Use the rotary 3 control to set the number of frames to be
written. Set 1 as the number of frames for Still writing and
set a number greater than 1 for Movie writing.
Check the image to be written at the Prog output, and
when the image to be written appears, write it using
"Enter." In the case of Movie, the images are written
consecutively from the page designated by the rotary 2
control up to the page equivalent to the number of frames
designated by the rotary 3 control. Any existing data will
be deleted in the process of image writing.
≥ Preview procedure
Use the rotary 5 control to set the mode to "Preview."
Use the rotary 2 control to select the page on which the
images are to be previewed. To preview Still, use the
rotary 4 control to select "Field" output or "Frame" output.
To preview Movie, use the rotary 3 control to set the
number of frames to be previewed and the rotary 4 control
to select "Repeat" (repeat) playback or "Once" (once-only)
playback. If a value exceeding the number of frames
written has been set by the rotary 3 control, the setting will
be ignored.
Start the preview using "Enter." Even when the page selected by the rotary 2 control is midway through the Movie, the
Movie is played back from its beginning.
If the settings are acceptable, use the rotary 5 control to set the mode to "Exit", then enter the settings using "Enter." The
page set is recalled by the "INTVideo" button and played back.
Even when another "Matte" or "CustomColor" selection has been set using "INTVideo" upon completion of the settings, the
images previously stored in the memory can be read by selecting "Memory" again but they will be cleared after the power is
turned off.
The playback trigger is applied using "Shift" + ".".
The "Grade" setting which was set by "BackMatte" also takes effect for "Memory."
<Note>
Images cannot be written during Movie playback. If images are to be written, first set [Mode] to [Exit] and press the [Enter]
button to exit Movie playback, and then proceed.
When Frame = 1
R1 R2
Memory Page
1
1 - 30/26
(NTSC/PAL)
When Frame > 1
R1 R2
Memory Page
1
1 - 30/26
(NTSC/PAL)
22
R3 R4 R5
Frame Mode
1 Field
1 - 30/26 Field Write
Preview
(NTSC/PAL) Frame
Exit
R3 R4 R5
Frame Mode
5F Repeat
Write
1 - 30/26 Repeat
(NTSC/PAL) Once Preview
Exit
Write
Write