Ipod Control - Panasonic Strada CN-NVD905U Upgrade Manual

iPod control

Preparation:
 Connect an iPod with the Direct cable for iPod
(CA-DC300U, option).
Controllable iPod/
software version
 3rd generation iPod/ver. 2.2 – 2.3
 4th generation iPod/ver. 3.0.2 – 3.1

5th generation iPod/ver. 1.0
(Video and photos cannot be displayed.)
 iPod Photo/ver. 1.0 – 1.2
(Photos cannot be displayed.)

iPod mini/ver. 1.2 – 1.4
 iPod nano/ver. 1.0
* Operation has been confi rmed for software available
at the end of February, 2007. We do not guarantee
proper operation with our future products or upgraded
software.
Note:
 Do not attach or detach the iPod while iPod is on.
Noise is generated which could damage the speakers.
 Use a holder or other means to ensure the iPod does
not move while the vehicle is in motion.
 Do not leave the iPod for long periods of time where
the inside of the vehicle will get hot.
 Also refer to the installation manual for the iPod to be
connected.
 After turning the engine off (switching from ACC to
OFF), always disconnect the iPod. If the iPod is left
connected, its power may not turn off, causing its
battery to run down.
 Please note that no compensation will be provided for
data lost from the iPod while it is used connected to
the main unit.

The iPod is licensed for duplication and playback
of material that is uncopyrighted, or may legally
be duplicated or played for individual private use.
Infringement of copyright is prohibited by law.

Do not connect iPod accessories such as a remote
control unit or headphones while the iPod is
connected to the main unit. They may not function
normally in some cases.

The iPod can only play music data.
 The iPod Shuffl e is not compatible.
12
12
Connecting an iPod to the system
 To connect the iPod
iPod
Dock connector port
 The iPod cannot be operated with its own
controls.
 The iPod charges while it is connected to the
main unit.
 To disconnect the iPod
Switch to iPod
Select [iPod] on the Audiovisual
source operation screen.
( Operating Instructions)
 The iPod operation screen is displayed.
 Plays the track.
Note:
 "Communication error" appears until the iPod is
recognized after connecting the iPod, turning on the
power of the main unit, or performing source selection
on the main unit. This indicates there is nothing wrong
with the main unit.

We do not guarantee operation of all the functions of
the iPod to be connected.
 Only iPods equipped with a dock connector can be
connected.
 is displayed even if only the connecting cable
(CA-DC300U, option) is connected to the unit.
Direct cable for iPod
(CA-DC300U, option)
Detach while pressing.