Panasonic SDR-H80 Operating Instructions Manual page 97

Problem
A clicking sound is heard
when the power is turned
off.
The screen has changed
suddenly.
(Demo mode is on)
A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.
Recording does not start
although power is
supplied to this unit.
Recording starts but
stops immediately.
The playback picture
breaks up for a moment.
The operation arbitrarily
stops.
≥ This is the sound of the lens moving and is not a
malfunction.
≥ If you set [DEMO MODE] to [ON] without inserting an SD
card in video recording mode or picture recording mode,
the unit is automatically set to the demonstration mode for
introducing its functions. Normally this should be set to
[OFF]. (l 23)
≥ If you set [SETUP] > [DISPLAY] > [OFF], indications
other than warnings and date are not displayed.
≥ No recording is possible while the SD card's write protect
switch is set to LOCK. (l 16)
≥ If the HDD or SD card has no more available memory, free
up some memory by deleting unnecessary scenes (l 54)
or use a new SD card.
≥ Is the unit set to the video recording mode or picture
recording mode?
≥ If the SD card slot cover is open, this unit may not operate
normally. Close the card slot cover.
≥ The unit is hot. Follow the messages on the display. To use
the unit again, turn the unit off and leave it for a while.
≥ If the recording stops when the HDD is used, back up the
data on the HDD to a PC, etc. and then format the HDD.
(l 66)
≥ If the unit is exposed to strong vibrations or shocks while
recording on HDD, recording may stop to protect the HDD.
If the unit is used in a place with loud sounds, the recording
may stop due to sound vibrations. Recording data on an SD
card is recommended in these places.
≥ The drop detection function has activated to protect the
HDD. Do not drop or shake this unit while operating it.
Check points
97
LSQT1484