Inserting/Removing An Sd Card - Panasonic HDC-SD1PP Operating Instructions Manual

Setup
3
Open the LCD monitor.
The status indicator A lights red and the unit
is put into recording pause approx.
1.7 seconds after it is turned on.
ª To cancel Quick start
Press the MENU button, then select [SETUP]
# [QUICK START] # [OFF] and press the
cursor button.
≥The status indicator goes off, the lens cover
closes and the power turns off if the mode dial
is set to OFF while the unit is in quick start
standby mode.
≥The status indicator goes off and the power
turns off if quick start standby mode continues
for approx. 5 minutes.
≥Quick start standby mode is canceled, the
status indicator goes off and the power turns off
in the following cases.
– the mode dial is switched
– the battery is removed
≥When this unit is quick-started with the white
balance on automatic, it may take some time
until the white balance is adjusted if the scene
being recorded has a light source different from
the scene last recorded. (When the MagicPix
function is used, however, the white balance of
the scene last recorded is retained.)
≥When this unit is quick-started, the zoom
magnification becomes 1k and the picture size
may differ from what it was before quick start
standby mode.
≥If [POWER SAVE] (l 107) is set to
[5 MINUTES] and the unit automatically goes
into quick start standby mode, close the LCD
monitor and then open it again.
34
VQT1A24
Inserting/removing an SD
card
A
Be sure to set the mode dial to OFF before

inserting/removing an SD card.

If the SD card is inserted or removed while the
power is on, this unit may malfunction or the
data recorded on the SD card may be lost.
1
Set the mode dial to OFF.
≥Check that the status indicator has gone
off.
2
Open the LCD monitor and then
open the card slot cover.
3
Insert/remove the SD card into/
from the card slot.
≥When inserting an SD card, face the label
side A upwards and press it straight in as
far as it goes.
≥When removing the SD card, press the
center of the SD card and then pull it
straight out.
4
Securely close the card slot
cover.
A