Connecting The Power Cords Of Other Components; Connecting The Power Cord - Onkyo TX-8555 Instruction Manual

Onkyo stereo receiver instruction manual

Hide thumbs Also See for TX-8555:

Instruction manual (48 pages)

Table of Contents

Connecting Your Components—Continued

With

(Remote Interactive), you can control your

-compatible Onkyo CD player, RI Dock, and so on

with the receiver's remote controller.

• To use

, you must make an analog audio

connection between the receiver and each audio

component.

Receiver

Onkyo CD player,

etc.

Onkyo cassette

deck, etc.

Remote Interactive

Dock, etc.

Notes:

• Push each plug in all the way to make a good

connection.

• Use only dedicated

cables for

(no

cables are supplied with the receiver).

•

jacks should be connected only to Onkyo

components. Connecting them to another

manufacturer's component may cause the receiver to

malfunction.

• Some components may not support all

See the manuals supplied with your other Onkyo

components for more information.

connector

Remote control cable

connections

functions.

Connecting the Power Cords of Other

Components

The receiver has AC outlets on its rear panel that can be

used to connect the power cords of other components

that you intend to use with the receiver. These

components can then be left turned on so that they turn

on and off as and when the receiver is turned on and set

to Standby.

e.g. European model

Caution:

• Make sure that the total capacity of the components

that you connect to the AC OUTLETS does not exceed

the stated capacity (e.g., TOTAL 120 W).

Notes:

• Onkyo components connected via

connected directly to a wall outlet, not an AC

OUTLETS on the receiver.

• The number of AC OUTLETS, socket type, and total

capacity depend on the country in which you

purchased the receiver.