Nortel 1140E User Manual page 19

Business communications manager
Hide thumbs Also See for 1140E:
Table of Contents

Advertisement

To pair the Bluetooth Headset with your phone:
1. Check with your administrator to ensure that Bluetooth is available for
your use.
2. Restart your IP Phone 1140E using one of the following methods:
If you are using an AC power adapter, unplug it, wait 10 seconds, and
reinsert it.
If you are using Power Over Ethernet (POE), unplug the LAN
Ethernet cable, wait 10 seconds, and reinsert it.
3. Double-press the
Enable Bluetooth
The
Note: If the
Bluetooth Setup
is not configured to support a Bluetooth headset; contact your system
administrator.
Enter
4. Press the
A check mark is displayed to indicate that Bluetooth is activated. The
message "BT Enabled" appears at the bottom of the display.
5. Put your Bluetooth headset in its pairing or search mode. The
procedure for doing this can be different for each Bluetooth headset.
Refer to the documentation that accompanied your headset, or
contact the vendor.
For example, if you are using the GN Netcom GN 6210, do the
following:
a. Turn the headset off by pressing and holding the
button for 3 - 4 seconds until a high to low tone is heard. The
headset blue LED turns off.
b. Press and hold the
the blue LED flashes and then lights steadily.
6. Search for (pair) the headset:
a. Press the
Search
button is shown next to the Search Devices item.
b. Press the
The message "Searching...." is displayed.
key access
check box is highlighted.
item appears dimmed, then your phone
key to activate Bluetooth.
telephone
Right
navigation key one or more times until the
Enter
key.
Configuring options
3. Bluetooth
setup.
button for about 8 seconds until
telephone
19

Advertisement

Table of Contents
loading

Table of Contents