Assembly - NordicTrack CX 998 NEL7095.2 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included allen wrenches, assembly requires a phillips screwdriver
wrenches
As you assemble the elliptical exerciser, use the drawings below to identify the small parts used in assembly.
The number in parenthesis below each drawing is the key number of the part, from the PART LIST on pages 24
and 25. The second number is the quantity used in assembly. Note: Some small parts may have been pre-
assembled. If a part is not in the parts bag, check to see if it is pre-assembled.
M6 Washer M8 Split
(64)–2 Washer
(30)–4
M4 x 16mm
M6 x 16mm Patch
Round Head
Screw (76)–4
Screw (69)–4
M8 x 44mm Button Screw (84)–8
M8 x 38mm Button Bolt
(105)–2
1. Identify the Front Stabilizer (8). While another person
lifts the front of the Frame (1) and holds the Pedal
Legs (4, 5) in the position shown, attach the Front
Stabilizer to the Frame with four M8 x 44mm Button
Screws (84) and a Support Plate (104).
While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (not shown) to the Frame
in the same way.
, a rubber mallet
7.6mm Spacer
M10 Split
Washer
(73)–2
M8 x 41mm Button
Bolt (85)–4
, and pliers
M8 Jam Nut
(109)–2 (86)–9
M8 x 56mm Button Screw (83)–4
M8 x 79mm Bolt Set (65)–2
M10 x 108mm Button Screw (70)–2
1
104
5
, two adjustable
.
M4 x 12mm
M4 x 16mm
Round Head
Screw (98)–2
Screw (96)–1
1
8
84
84
4, 5