Configuration Profile; Dg834G V3 With Fqdn To Fvl328 - NETGEAR DG834G Reference Manual

Reference Manual for the ADSL Modem Wireless Router DG834G
3. Test the VPN tunnel by pinging the remote network from a PC attached to the DG834G v3.
a. Open the command prompt (Start -> Run -> cmd)
b. ping 172.23.9.1
Figure B-4
Note: The pings may fail the first time. If this happens, try the pings a second

DG834G v3 with FQDN to FVL328

This appendix is a case study on how to configure a VPN tunnel from a NETGEAR DG834G v3 to
a FVL328 using a Fully Qualified Domain Name (FQDN) to resolve the public address of one or
both routers. This case study follows the VPN Consortium interoperability profile guidelines
(found at http://www.vpnc.org/InteropProfiles/Interop-01.html).

Configuration Profile

The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
B-6
time.
v1.3, March 2007
NETGEAR VPN Configuration