Netgear Vpn Configuration; Dg834G V3 To Fvl328; Configuration Profile - NETGEAR DG834G Reference Manual

DG834G v3 to FVL328

This appendix is a case study on how to configure a secure IPSec VPN tunnel from a NETGEAR
DG834G v3 to a FVL328. This case study follows the VPN Consortium interoperability profile
guidelines (found at http://www.vpnc.org/InteropProfiles/Interop-01.html).

Configuration Profile

The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Table 0-1. Profile Summary
VPN Consortium Scenario:
Type of VPN
Security Scheme:
IP Addressing:
NETGEAR-Gateway A
NETGEAR-Gateway B

NETGEAR VPN Configuration

NETGEAR VPN Configuration
Scenario 1
LAN-to-LAN or Gateway-to-Gateway (not PC/Client-to-Gateway)
IKE with Preshared Secret/Key (not Certificate-based)
Static IP address
Static IP address
v1.3, March 2007
Appendix B
B-1