Sound Bar Setup - NEC MultiSync LCD1770V User Manual

Sound bar Setup

To attach the MultiSync sound bar 70 to your LCD1770NXM, follow these
instructions. Note: this setup is only for the LCD1770NXM. If you have purchase
an LCD1770V or LCD1770NX, please move to the next page.
1. Turn off the computer.
2. Place hands on each side of the display to tilt up the panel and then lift up to the
highest position.
3. Use the two thumb screws included to attach the MultiSync sound bar 70 to the display
(Figure SB.1).
4. Turn the volume control down on the MultiSync soundbar 70 (Figure SB.2).
5. Connect the light blue color audio cable plug to the light blue jack of MultiSync sound
bar 70 (Figure SB.1). Connect the other end of the audio cable into the back of your
computer.
NOTE: Headphones may be connected to the headphones jack on the right side of the
MultiSync sound bar 70 (Figure SB.2). Headphones can be purchased from your local
electronics store.
6. Connect the DC power cable of sound bar 70 to DC-OUT terminal of display (Figure
SB.1).
7. You are now ready to move to the next step in setting up your MultiSync LCD.
Figure SB.1
Figure SB.2
LCD17PISAManual080604.p65
DC-OUT Terminal
of Display
Thumb
Screw
Audio
Cable
Headphone Jack
VOL.
VOL.
Volume Control
28
28
Thumb
Screw
DC Power
Cable
8/6/04, 5:15 PM