National Instruments NI 784xR User Manual page 64

Ni r series intelligent daq

Hide thumbs Also See for NI 784xR:

Table of Contents

Using the SCB-68

Shielded Connector Block

This appendix describes how to connect input and output signals to the

NI 78xxR with the SCB-68 shielded connector block.

The SCB-68 has 68 screw terminals for I/O signal connections. To use

the SCB-68 with the NI 78xxR, you must configure the SCB-68 as a

general-purpose connector block. Refer to Figure B-1 for the

general-purpose switch configuration.

Figure B-1. General-Purpose Switch Configuration for the SCB-68 Terminal Block

After configuring the SCB-68 switches, you can connect the I/O signals to

the SCB-68 screw terminals. Refer to Appendix A,

for the connector pin assignments for the NI 78xxR. After connecting

I/O signals to the SCB-68 screw terminals, you can connect the

SCB-68 to the with the SHC68-68-RMIO (for Connector 0 on the

NI 783xR/784xR/785xR) or SHC68-68-RDIO (Connector <0..3> on the

NI 781xR and Connector <1..2> on the NI 783xR/784xR/785xR) shielded

cables.

S5 S4 S3

B-1

Connecting I/O

Signals,

R Series Intelligent DAQ User Manual

Table of Contents

Ni 785xr Ni 781xr Ni 783xr 784xr Ni r series