National Instruments NI 784xR User Manual page 59

Ni r series intelligent daq
Hide thumbs Also See for NI 784xR:
Table of Contents

Advertisement

Appendix A
Connecting I/O Signals
Signal Name
+5V
Analog Signals (NI 783xR/784xR/785xR Only)
AI<0..7>+
AI<0..7>–
AIGND
AISENSE
AO<0..7>
AOGND
Digital Signals (All NI 78xxR Devices)
DGND
DIO<0..39>
Connector<0..3>
(NI 781xR)
DIO<0..15>
Connector 0
(NI 783xR/784xR/785xR)
DIO<0..39>
Connector <1..2>
(NI 783xR/784xR/785xR)
R Series Intelligent DAQ User Manual
To access the signals on the I/O connectors, you must connect a cable from
the I/O connector to a signal accessory. Plug the small VHDCI connector
end of the cable into the appropriate I/O connector and connect the other
end of the cable to the appropriate signal accessory.
Table A-1. I/O Connector Signal Descriptions
Reference
Direction
DGND
Output
AIGND
Input
AIGND
Input
AIGND
Input
AOGND
Output
DGND
Input or
Output
+5 VDC Source—These pins supply 5 V from the computer
power supply. For more information on the +5V terminals,
refer to the
+5 V Power Source
Hardware Overview of the NI
Positive input for Analog Input channels 0 through 7.
Negative input for Analog Input channels 0 through 7.
Analog Input Ground—These pins are the reference point
for single-ended measurements in RSE configuration and
the bias current return point for differential measurements.
All three ground references—AIGND, AOGND, and
DGND—are connected to each other on the
NI 783xR/784xR/785xR.
Analog Input Sense—This pin serves as the reference node
for AI <0..7> when the device is configured for NRSE mode.
Analog Output channels 0 through 7. Each channel can
source or sink up to 2.5 mA.
Analog Output Ground—The analog output voltages
are referenced to this node. All three ground
references—AIGND, AOGND, and DGND—are
connected to each other on the NI 783xR/784xR/785xR.
Digital Ground—These pins supply the reference for the
digital signals at the I/O connector and the 5 V supply.
All three ground references—AIGND, AOGND, and
DGND—are connected to each other on the
NI 783xR/784xR/785xR.
Digital I/O signals.
A-4
Description
section in Chapter 2,
78xxR.
ni.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ni 785xrNi 781xrNi 783xr784xrNi r series

Table of Contents